Prijon Repair Stick PE

Product no.: 10114011-0001

5.60 €
incl. VAT, plus delivery
In stock

Description

For Plastics Repair.

To melt the pencil you will need a professional hot glue gun or a hot air blower that is around 350 degrees or a hot gun,

which can produce about 220 degrees.

The pen is heated with the hairdryer just in front of the nozzle. Always turn the pen.

If you hold the hair dryer relatively close to the boat, the hull should be at 30 to max. Heat 40 degrees.

In addition, the fuselage melts and is irretrievably deformed.

Now vigorously turn the softened mass on the outside of the pin into the scratching furrows, creating a "weld bead".

Only when the material has cooled down, straighten it with a sharp blade (sharp Stanley plane or carpet knife - be careful with your fingers!).

Then fill in any grooves and pores that may still be present.

You can fill in scratches and scrapes permanently.

Screw holes that are not required can also be perfectly sealed. Fill from the outside and inside if possible!

Of course, you can try melting a kinked, cracked, or broken hull with the repair pen.

The melting point remains harder and may burst open again under load, but it is a try with the little effort

always worth it!

Diverse colours.

13cm length

almost 12mm in diameter

12g

Prijon recommends the device for processing:

Bickers Glue Jet Exakt VE 212 from www.bickers.de
 

Additional product information

Farbe
orange