Special production for boats without Lettmann seat shell.
The center of this super cushion remains the fine-pored and super-stable HDPE80 foam.
This adapts to your spine after a few trips and therefore provides extensive support.

Special production for boats without Lettmann seat shell.
The center of this super cushion remains the fine-pored and super-stable HDPE80 foam.
This adapts to your spine after a few trips and therefore provides extensive support.
The ingenious elasticity gently cushions your movements.
On the front of the plate is a soft foam in "mat hardness" mounted.
It also cushions fine structures in a controlled manner.
The whole thing is sewn around by our strong Cordura fabric and therefore finally free of glue spots that could come loose at some point.
On the back of the plate there are belt loops for the back belt and for a suspension with elastic cord.
The plate is pushed onto the back strap and fits behind the seat shell.
A firm and comfortable support that is also aimed at paddlers with spinal problems.
All foams are closed-cell. Therefore the plate dries very quickly.
In boats without a backrest guide groove in the seat shell, the assembly of supporting backrests is critical.
This is why this backrest is made in such a way that it rests on the bottom of the boat behind the seat shell.
So that the rear edge of the seat shell does not push the backrest upholstery too far away from the back, the backrest upholstery protrudes far forward.
Variant 1 long:
Perfect back support for boats with a high cockpit rear edge or a short life jacket design.
The high plate is ideal for higher boats, two-person kayaks or paddlers who need a lot of support.

• 35cm width
• 30cm height
• approx. 50mm thickness
• 400g

Variant 2 short:
Perfect back support for boats with a low cockpit rear edge or long life jacket design.
The short plate is ideal for small-volume boats or paddlers who need a lot of freedom of movement.

• 34cm width
• 28cm height
• approx. 50mm thickness
• 400g